Safety
13
Pos: 10.6.8 /BA/ Sicherheit/Zapf wellenbetrieb V orsätze/Feld häcksler @ 13\ mod_1225450 981661_78.doc @ 156341
3.5 PTO Operation
1 Use only PTO shafts specified by the manufacturer!
2 The guard tube and guard cone of the PTO shaft and the PTO guard must be attached
and in good working condition (on the implement side, too)!
3 Make sure that the required tube covers are in place for PTO shafts in transport and
working position!
4 Before installing or detaching PTO shafts, disengage the PTO, switch off the engine and
remove the ignition key!
5 When using PTO shafts with an overload safety or free-running coupling which are not
shielded by the guard on the tractor, mount the overload safety or free-running coupling
on the implement side!
6 Always make sure that the PTO shaft is properly installed and secured!
7 Attach chains to prevent the PTO shaft guard from rotating with the shaft!
8 Before switching on the PTO, make sure that the selected PTO speed of the forage
harvester matches the permissible speed of the implement!
9 Before switching on the PTO shaft make sure that no person is in the danger zone of the
device!
10 Never switch on the PTO if the engine is switched off!
11 No one should be in the vicinity of the rotating PTO or PTO shaft when the PTO is in use.
12 Always switch off the PTO shaft when the angle is too large or the PTO shaft is not
required!
13 Caution! After disengaging the PTO danger due to the flywheel running on! Keep away
from the implement during this time. Do not work on the machine until it has come to a
standstill.
14 Cleaning, lubricating or adjusting PTO driven implements or the PTO shaft only with PTO
disengaged, engine switched off and ignition key withdrawn!
15 Place the disconnected PTO shaft onto the support provided!
16 After detaching the PTO shaft, attach the protective cover to the PTO end!
17 If damage occurs, correct this immediately before using the implement!
Pos: 10.6.9 /BA/ Sicherheit/Zapf wellenbetrieb Zu satz @ 2\ mod_120352476 1314_78.doc @ 66513
Note
The instructions of the manufacturer must be observed with regard to the PTO shaft. (separate
operating instructions)
Pos: 10.6.10 /B A/-----Seitenu mbruch------ @ 0\mod_119617 5311226_0.doc @ 4165
To Next Page
Loading...
Need help?
General