Placing in Storage
60
Pos: 22.1 /Übersc hriften/Übersc hriften 1/A-E/Ei nlagerung @ 0\mod_11973 85459120_78.d oc @ 19966
10 Placing in Storage
Pos: 22.2 /BA/Einl agerung/EasyC ut/Einlageru ng allgemein o hne Bereifung @ 3\mod_120 4731079008_78. doc @ 72747
Before placing the machine in winter storage, clean inside and outside thoroughly. If you use a
high-pressure cleaner to do this. do not keep a stream of water directed at bearing points. After
cleaning is completed, lubricate all lubrication points. Do not wipe off any grease that comes out
of bearing points. The hardened grease will provide additional protection against moisture.
Oil all joint points!
Check all movable components such as deflector rollers, joints, tension rollers, etc. to make
certain they move easily. If necessary remove, clean, grease and remount. If necessary,
replace with new parts.
Use only original KRONE replacement parts.
Disassemble the PTO shaft. Lubricate the inner tubes and the guard tube with grease. Grease
the lubrication points on the cross joint and on the bearing rings of the guard tubes.
Touch up damaged paint and preserve all uncoated areas thoroughly with rust protection agent.
Park the machine in a dry location, but not in the vicinity of artificial fertilisers or livestock
buildings.
Perform the necessary repair tasks during the time immediately after the harvest season. Draw
up a list of all replacement parts you will need. This will make it easier for your KRONE dealer to
process your orders and you will be certain that your machine will be ready for use at the
beginning of the next season.
Pos: 22.3 /BA/---- -Seitenumbruch-- ---- @ 0\ mod_1196175311 226_0.doc @ 4165
To Next Page
Loading...
Need help?
General