Operation
28
Pos: 16.1 /Übersc hriften/Übersc hriften 1/A-E/B edienung @ 0 \mod_119978 9505403_78.doc @ 34825
6 Operation
Pos: 16.2 /Übersc hriften/Übersc hriften 2/U-Z/V on Transport in Arbeitsstellu ng @ 2\mod_12 02466185276_ 78.doc @ 596 62
6.1 From transport into working position
Pos: 16.3 /BA/Sich erheit/Gefahr enhinweise/Vors ätze/Absen ken des Vorsatzes @ 15\mod_ 12327080757 10_78.doc @ 176250
Danger! - Lowering the machine into working position
Effect: Danger to life, injuries or damage to the machine.
• Do not lower the machine until you are absolutely sure that neither persons, animals nor
objects are in the swivel range of the machine.
• Keep persons out of the danger zone. If persons do approach the danger zone, turn off
the machine immediately.
• Never leave the machine running unsupervised.
• Check the safety devices each time before the machine is used. Replace damaged
safety devices immediately.
• Do not work on the front attachment until the engine has been stopped and the ignition
key has been removed. All operating levers should be in the neutral position and no
hydraulic lines should be under pressure.
• Always check the attachment before use and after driving into an obstacle. Worn,
damaged or deformed blades must be replaced immediately. This also applies to
holders.
• Do not switch on the drive until the front attachment is in the working position.
Pos: 16.4 /BA/Be dienung /Vors ätze/Schneid werk/Arbeitsstellu ng X-Disc @ 12\mod_12247 41052482_78.d oc @ 15317 4
6.1.1 Working position
Fig. 12:
Lower the cutting system (1) down to the ground.
Pos: 16.5 /BA/---- -Seitenumbruch-- ---- @ 0\ mod_1196175311 226_0.doc @ 4165
To Next Page
Loading...
