ELECTRICAL SYSTEM 126
800098-10
– Pull off connectors , and .
– Take off rubber cap of the headlight bulb.
800099-10
– Turn holder about 30° counterclockwise and remove it.
– Remove headlight bulb.
– Insert a headlight bulb in the holder.
Headlight (S2 / socket BA20d) ( p. 168)
– Insert the holder into the headlight housing and fix it by turning it approx. 30° clock-
wise.
– Replace the rubber cap. Attach the connector.
– Install the headlight mask with the headlight. ( p. 124)
13.9Changing the parking light bulb
Note
Damage to reflector Reduced luminance.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
– Remove the headlight mask with the headlight. ( p. 122)
To Next Page
Loading...
Need help?
General
