CONTROLS 29
800083-19
– Switch on the ignition by turning the ignition key to position ON .
– Press the M button repeatedly until the Trip 1 mode is active.
– Keep the S button pressed.
The Trip 1 display is set to 0.00.
5.20Combination instrument - setting/resetting TRIP 2
Info
The TRIP 2 trip counter runs constantly and counts up to 999.9.
The trip counter can be used to measure the distance covered during trips or between two refueling stops. After the value 999.9 is
reached, the trip counter starts at 0.0 again.
800083-20
– Switch on the ignition by turning the ignition key to position ON .
– Press the M button repeatedly until the Trip 2 mode is active.
– Keep the S button pressed.
The Trip 2 display is set to 0.00.
To Next Page
Loading...
Need help?
General
