CONTROLS 28
800083-18
– Switch on the ignition by turning the ignition key to position ON .
– Press the M button repeatedly until the Odo mode is active.
– Keep the M button and the S button pressed simultaneously.
The time display begins to flash.
– Press the M button to set the hour.
– Press the S button to set the minute.
– Keep the M button and the S button pressed simultaneously.
The time is set.
5.18Combination instrument - display ODO
800083-18
In the Odo display mode, the total distance traveled is shown in kilometers or miles.
Info
This value is retained, even if the battery is disconnected and/or the fuse blows.
5.19Combination instrument - setting/resetting TRIP 1
Info
The TRIP 1 trip counter runs constantly and counts up to 999.9.
The trip counter can be used to measure the distance covered during trips or between two refueling stops. After the value 999.9 is
reached, the trip counter starts at 0.0 again.
To Next Page
Loading...
Need help?
General
