ELECTRICAL SYSTEM 127
800100-10
– Pull bulb socket out of the reflector.
– Pull parking light bulb out of the bulb socket.
– Insert a new parking light bulb in the bulb socket.
Parking light (W5W / socket W2.1x9.5d) ( p. 168)
– Insert the bulb socket in the reflector.
– Install the headlight mask with the headlight. ( p. 124)
13.10Changing the turn signal bulb
Note
Damage to reflector Reduced luminance.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
100301-10
– Remove the screw on the rear of the turn signal housing.
– Tilt headlamp diffuser forward carefully and take it off.
– Lightly squeeze the orange plug in the area of the holding lugs and take it off.
– Press the turn signal bulb carefully into the socket, turn it counterclockwise by about
30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
– Press the new turn signal bulb carefully into the socket and turn it clockwise until it
stops.
To Next Page
Loading...
Need help?
General
