15 ELECTRICAL SYSTEM 72
B01686-11
– Position the battery in the battery compartment.
Info
Ensure that the battery cable is correctly routed.
– Attach fastening plate 5.
– Mount and tighten screw 6.
Finishing work
–
Install the shock absorber. x ( p. 44)
– Lock the seat. ( p. 45)
– Remove the motorcycle from the lift stand. ( p. 37)
15.3 Recharging the battery x
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
– Keep batteries out of the reach of children.
– Wear suitable protective clothing and goggles.
– Avoid contact with battery acid and battery gases.
– Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
– In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Warning
Environmental hazard The battery contains elements that are harmful to the environment.
– Do not discard batteries with the household waste. Dispose of faulty batteries in an environmentally compatible manner.
Give the battery to your authorized KTM dealer or dispose of it at a collection point for used batteries.
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Even when there is no load on the battery, it discharges steadily.
The charge state and the type of charge are very important for the service life of the battery.
Rapid recharging with a high charging current shortens the battery's service life.
If the charging current, charging voltage, and charging time are exceeded, electrolyte escapes through the safety valves. This
reduces the battery capacity.
If the battery is depleted from starting the vehicle repeatedly, the battery must be charged immediately.
If the battery is left in a discharged state for an extended period, it will become over-discharged and sulfate, destroying the
battery.
The battery is maintenance-free, i.e., the acid level does not have to be checked.
Preparatory work
– Switch off all power consumers and switch off the engine.
– Raise the motorcycle with the lift stand. ( p. 37)
– Fold the seat up. ( p. 45)
–
Remove the shock absorber. x ( p. 44)
–
Remove the battery. x ( p. 71)
To Next Page
Loading...
Need help?
General
