16 KTM POWERPACK, BATTERY CHARGER 98
7 Status indicator
8 LED for KTM PowerPack fault
9 LED for charger fault
16.4 Positioning the battery charger
Warning
Risk of injury There is a risk of electric shock in a moist environment.
The battery charger is not waterproof.
– Only use the battery charger in dry conditions.
– Ensure that no fluids flow or drip onto the battery charger.
Warning
Risk of injury If the battery charger is used incorrectly, its intrinsic safety cannot be guaranteed.
The battery charger is only suitable for use with a KTM PowerPack.
– Only use the battery charger with a KTM PowerPack.
– Only operate the battery charger using household sockets with an earth conductor.
– Do not use any additional adapters or extensions.
– Follow the applicable safety instructions of the power connection.
Warning
Risk of injury There is a risk of electric shock if the battery charger or the cables have been manipulated or damaged.
The battery charger does not contain any parts which require maintenance.
– Do not modify the battery charger or the cables.
– Under no circumstances open the battery charger housing.
– Do not insert any objects into the battery charger housing from the outside.
– Do not use the battery charger if cables, plug or parts of the battery charger have been damaged or are soiled.
C00766-01
– Place the battery charger on a firm, level and horizontal surface.
– Ensure the battery charger is adequately ventilated.
Guideline
Free space at the front and rear side of
the battery charger
20 cm (7.9 in)
– Use the battery charger in the temperature range permitted.
Guideline
Ambient temperature −15… 50 °C (5… 122 °F)
– Ensure that the power plug for the battery charger always remains easily accessible.
16.5 Checking residual current protection switch
K00031-10
Warning
Risk of injury There is a risk of electric shock with a faulty residual current
protection switch.
– Before each use of the charger check the residual current protection
switch.
– Do not use the residual current protection switch if the test procedure
was not successful.
– Connect the mains plug to the mains connection.
–
Press the
button.
The operating display lights up red.
–
Press the
button.
The operating display goes out.
–
Press the
button.
The residual current protection switch can be used.
To Next Page
Loading...
Need help?
General
