22 TROUBLESHOOTING 116
22.3 Troubleshooting of the KTM PowerPack when connected to the battery charger
402155-10
The faults are indicated by LED
on the battery charger. All of the following blink
codes are displayed on the charger and refer to the KTM PowerPack.
Tip
The first step to take in case of any fault is to switch off the battery charger,
wait for 15 seconds, and then switch it back on.
If a fault is not eliminated by the measures specified here, an authorized KTM
workshop will be happy to help you.
Info
The pause between the signals of the 1st digit is 0.25 seconds.
The pause between the 1st and 2nd digits is 1 second.
The pause between the signals of the 2nd digit is also 0.25 seconds.
The pause until the blink code repeats is 3 seconds.
Faults Possible cause Action
Blink code 11 on battery charger Charging fault – Check the charging plug and charging cable for
external damage and dirt and reconnect.
Blink code 33 on battery charger Overtemperature of the
KTM PowerPack
– Let the KTM PowerPack cool down.
Blink code 34 on battery charger Undertemperature of the
KTM PowerPack
– Place the KTM PowerPack in a warmer location
and let it warm up.
– Continue charging in a warmer location.
Blink code 36 on battery charger Undertemperature of the
KTM PowerPack
– Place the KTM PowerPack in a warmer location
and let it warm up.
– Continue charging in a warmer location.
Blink code 64 on battery charger Charging cable detected in activated
vehicle
– Switch off the main switch on the vehicle and
restart charging.
Blink code 65 on battery charger Fault in the charging cable – Check the charging plug and charging cable for
external damage and dirt and reconnect.
Blink code 66 on battery charger The KTM PowerPack charge level
is too high for the Storage charging
mode
– Ride the vehicle until the KTM PowerPack is
depleted to below 50%.
Blink code 73 on battery charger The KTM PowerPack is not enabled – Contact an authorized KTM workshop.
To Next Page
Need help?
General
