KTM Freeride E-XC User Manual

12 SERVICE WORK ON THE CHASSIS 54
C00801-11
(Freeride E‑XC)
–
Position the fork protector on the left fork leg. Mount and tighten screws

.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
– Position the brake line, wiring harness, and clamp. Mount and tighten
screws

.
Finishing work
– Install the KTM PowerPack. ( p. 96)
– Lock the seat. ( p. 63)
12.9 Removing the lower triple clamp
Preparatory work
– Deactivate the vehicle. ( p. 37)
– Fold the seat up. ( p. 63)
– Remove the KTM PowerPack. ( p. 96)
– Mount the covering cap. ( p. 64)
– Raise the motorcycle with a lift stand. ( p. 49)
– Remove the front wheel. ( p. 83)
(Freeride E‑SX)
– Remove the start number plate. ( p. 60)
(Freeride E‑XC)
– Remove the headlight mask with the headlight. ( p. 91)
– Remove the front fender. ( p. 61)
– Remove the fork legs. ( p. 50)
C00715-10
Main work
(Freeride E‑SX)
–
Open holder

and detach the wiring harness and brake line.
C00694-10
–
Remove screw

.
–
Remove screw

.
– Take off the upper triple clamp with the handlebar and set it aside.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
C00693-10
–
Remove O-ring

and protective ring

.
– Take off the lower triple clamp with the steering stem.
– Remove the upper steering head bearing.

KTM Freeride E-XC Specifications

General

Brand	KTM
Model	Freeride E-XC
Category	Motorcycle
Language	English