13 BRAKE SYSTEM 72
13.4 Checking the brake discs
Warning
Danger of accidents Reduced braking efficiency due to worn brake disc(s).
– Change the worn brake disc(s) without delay.(Your authorized KTM workshop will be glad to help.)
400257-10
– Check the thickness of the front and rear brake discs at several places on the disk
to see if it conforms to measurement
.
Info
Wear reduces the thickness of the brake disc around the area used by the
brake linings.
Brake discs - wear limit
Front 2.5 mm (0.098 in)
Rear 3.5 mm (0.138 in)
» If the brake disc thickness is less than the specified value:
– Change the brake disc.
– Check the front and rear brake discs for damage, cracking and deformation.
» If the brake disc shows signs of damage, cracking, or deformation:
– Change the brake disc.
13.5 Checking the brake fluid level of the front brake
Warning
Danger of accidents Brake system failure.
– If the brake fluid level drops below the specified marking or the specified value, this is an indication that the brake sys-
tem is leaking or that the brake linings are completely worn down. Check the brake system and do not continue riding.(Your
authorized KTM workshop will be glad to help.)
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
– Change the brake fluid of the front and rear brake according to the service schedule.(Your authorized KTM workshop will be
glad to help.)
C00723-10
(Freeride E‑SX)
– Move the brake fluid reservoir attached to the right of the handlebar to a hori-
zontal position.
–
Check the brake fluid level in level viewer
.
»
If the brake fluid has dropped below marking
:
– Add front brake fluid. ( p. 73)
C00807-10
(Freeride E‑XC)
– Move the brake fluid reservoir attached to the right of the handlebar to a hori-
zontal position.
–
Check the brake fluid level in level viewer
.
»
If the brake fluid has dropped below marking
:
– Add front brake fluid. ( p. 73)
To Next Page
Loading...
Need help?
General
