16 KTM POWERPACK, BATTERY CHARGER 101
Info
The charge level of the KTM PowerPack must be below 50% before the Storage charging mode can be used.
If the temperature of the KTM PowerPack exceeds the permissible value while it is being charged, the charger stops charging.
All LEDs and the LEDS for the current charge level alternately light up every second.
After the temperature of the KTM PowerPack returns to the permissible range, charging is resumed automatically.
Preparatory work
– Position the battery charger. ( p. 98)
C00815-10
Main work
–
Remove the charging socket protection cap
.
Warning
Risk of injury The intrinsic safety of the KTM PowerPack can only be guar-
anteed if the original battery charger is used.
The KTM PowerPack may only be charged with the original battery charger.
– Only use the original battery charger to charge the KTM PowerPack.
–
Connect the battery charger to the KTM PowerPack. Observe plug markings
.
C00768-10
– Connect the power plug for the battery charger to the power supply socket.
–
Set the charging mode switch
to the Storageposition.
C00769-10
–
Switch on the battery charger using switch
.
The charging process starts automatically. The status indicator flashes during
the charging process.
C00854-01
– Monitor the charging level of the KTM PowerPack using the LEDs.
LED 1: 20%
LED 2: 40%
After the charging process is completed to a level of 50%, LEDs 1 and 2 light up
and the status indicator goes out.
To Next Page
Loading...
Need help?
General
