Kubota D1302-B User Manual

KiSC issued 09, 2007 A


(3) Checking Test Terminals L-E/N-E/B-E/B-L
1) Test the termi n als L-E, N-E, 8-E a nd 8-L with the same
method as above.
• R esista nces of regu lator
The nomi na
l resista nces between term i nals of t he reg u lator
a re given below for reference.
NOTES:
a) "Pull" means the condition where the armature point is contacting the high-speed side point P2
with finger pressure only.
b) "Stationary" means the condition where the armature point is in contact with the low-speed side
point P1.
79
-
Terminals
Volta
g
e Volta
g
e
Normal
L - E
(
white/red
)
(
black
)
Relay
Stationary
state
Re_g_'::'_lator
Resistance
n
Failure and Probable Causes
-
0
Pull
a
pp
rox. 100
1-
-
-
·---··
N
-
-·-- ·- -·-- ' ..
(
white/black
)
(
black
)
-
B
- E
(
white
)
(
black
)
Stationar
y
-
approx.
--·· ·
00
23
B
(
white
)
·-·
L
(white/red)
Pull
-
0
If reading is over 0, bad contact on
voltage relay point P1.
If reading is 0, deposition occurs on
voltage relay point P1.
If reading is oo, voltage coil is cut.
If reading is 0, relay coil is shorted.
If reading is ""', pressure coil is cut.
If reading is not oo voltage relay
point P2 is melted and burned.
If reading is over 0, bad contact on
volta
g
e rela
y
_p
oint P2.

Kubota D1302-B Specifications

General

Brand	Kubota
Model	D1302-B
Category	Engine
Language	English