Kubota G2160 User Manual

2-M3
G2160, WSM
TRANSMISSION AND REAR AXLE
[2] OIL FLOW
1. When the engine is started, the charge pump is rotated to suck oil from the transmission case through the suction
pipe (8).
2. When the oil is sucked, it is filtered by the oil stainer.
3. Filtered oil is forced out by the charge pump to the control valve through the control valve adaptor (5).
4. With the control valve (3) in neutral position, the oil is delivered to the hydrostatic transmission through the control
valve adaptor (5) and oil filter cartridge (4).
5. The oil used to charge a leak of the closed circuit in the hydrostatic transmission.
6. A portion of oil is drained into the rear axle cases (2), (7) through drain pipe (9) and drain hoses (1), (6) after flushing
and cooling the cylinder blocks.
W1013278
(1) Drain Hose
(2) Rear Axle Case
(3) Control Valve
(4) Oil Filter Cartridge
(5) Control Valve Adaptor
(6) Drain Hose
(7) Rear Axle Case
(8) Suction Pipe
(9) Drain Pipe
KiSC issued 11, 2006 A

Kubota G2160 Specifications

General

Brand	Kubota
Model	G2160
Category	Tractor
Language	English