Kubota G2160 User Manual

5-S15
G2160, WSM
STEERING
5. CHECKING, DISASSEMBLING AND SERVICING
[1] CHECKING AND ADJUSTING
(1) Warning Lamp
Checking of EPS System
When the main switch is set to the ON position (B), the EPS
controller detects the voltage signal from the oil switch (1) and
makes the warning lamp (2) glow for 5 seconds.
■ Check Test
1. Start the engine.
2. Check that the warning lamp glows for 5 seconds and then goes
off.
3. If the warning lamp does not go on, check if the harness is
connected properly.
4. If the warning lamp does not stop glowing, replace the EPS
controller and check again.
W1012253
(1) Oil Switch
(2) Warning Lamp
(A) MAIN SWITCH
(B) OIL SWITCH
(C) WARNING LAMP
(D) Going on
(E) Going off
(a) Off
(b) On
(c) Close
(d) Open
(e) 5 sec.
KiSC issued 11, 2006 A

Kubota G2160 Specifications

General

Brand	Kubota
Model	G2160
Category	Tractor
Language	English