Kubota G2160 User Manual

2-M5
G2160, WSM
TRANSMISSION AND REAR AXLE
[4] CHARGE PUMP
The charge pump is necessary to make up for leakage from the pump and motor, preventing cavitation.
This charge pump always revolves in combination with the pump shaft to draw oil from the transmission case, and
feeds oil to the implement lifting circuit and charge circuit.
[Charge Pump Displacement]
As for charge circuit of the charge pump, refer to Workshop Manual for G1700 ·
G1800 · G1900 · G2000 (code No.
9Y021-10834).
[Charge Relief Valve]
W1014384
(1) Charge Relief Valve
(2) Charge Pump Housing
(3) O-ring
(4) Charge Pump Spacer
(5) O-ring
(6) Gerotor
(7) Dowel Pin
(8) Center Section
(9) Needle Bearing
(10) Internal Snap Ring
(11) Oil Seal
(12) Needle Bearing
(13) Dowel Pin
(14) Drive Pin
(15) Pump Shaft
Displacement Engine speed Oil pressure Oil temperature
2.8 to 5.0 L/min.
3.0 to 5.4 U.S.qts./min.
2.4 to 4.49 lmp.qts./min.
1800 min
-1
(rpm)
3.43 MPa
35 kgf/cm
2
498 psi
Approx. 50 °C
122 °F
Engine speed Oil temperature
Valve operating
pressure
1800 min
-1
(rpm)
Approx. 50 °C
122 °F
0.32 to 0.4 MPa
3.3 to 4.2 kgf/cm
2
47 to 60 psi
KiSC issued 11, 2006 A

Kubota G2160 Specifications

General

Brand	Kubota
Model	G2160
Category	Tractor
Language	English