G-13
G2160, WSM
G GENERAL
Checking Engine Oil Level
CAUTION
• To avoid personal injury : Always stop the engine and
remove the key before checking oil.
1. Check engine oil before starting and 5 minutes or more after the
engine has stopped.
2. Wipe dipstick area clean.
3. To check the oil level, remove the dipstick (2), wipe it clean,
replace it, and draw it out again. Check to see that the oil level is
between the two notches.
4. Add new oil to the prescribed level at the oil port if necessary.
IMPORTANT
• Use the specified engine oil.
Refer to “LUBRICANTS, FUEL AND COOLING WATER”.
(See page G-8)
• When using new oil of a different maker or viscosity from the
previous one, drain all used oil.
Never mix two different types of oil.
W1021025
(1) Oil Inlet Plug
(2) Dipstick
(A) Upper Level
(B) Lower Level
To Next Page
Loading...
Need help?
General
