Kubota GL9000D-AU-B User Manual

GENERATOR
GL6000A-AU-B, GL6000D-AU-B,GL9000A-AU-B, GL9000D-AU-B, WSM
2-S4
[2] ENGINE CIRCUIT
9Y1211607GRS0002US0
Trouble Cause Confirmation Countermeasure
Engine Stops
(The Engine Stops
Approximately
10 Seconds After
Starting.)
Insufficient engine oil Check the oil level Add the engine oil
Defective oil pressure switch Check the oil pressure
switch
Replace
Defective water temperature sensor Check the water
temperature sensor
Replace
Defective wiring harness Check the wiring harness Repair or replace
Engine Stops Engine room door is opened Check the engine room
door
Close
Safety switch is failure Check the safety switch Replace
Water temperature is too high Check the coolant level Replace
Over heat Check the monitor and
the radiator clog
Repair or replace
Engine breakdown Check the engine
exterior and oil level
Repair or add the
engine oil
Insufficient engine oil Check the oil level Add the engine oil
Insufficient fuel Check the fuel level Add the fuel
The Charge Lamp
Lights/Alternator
Charge Fail
Illuminates After the
Engine Starts
Disconnected wiring harness or
short-circuit
Check the wiring harness Repair or replace
Defective A.V.R. Check the A.V.R. Replace
Disconnected sub coil Check the sub coil Replace
Improper contact of sub coil wiring part Check the sub coil and
wire harness
Repair or replace
Charge Lamp Does
Not Light Even with
the Key Switch
Turned "ON" When
the Engine Is
Stopped
Burnt out 10 A fuse Check the fuse (10 A)
and the wiring
Repair or replace
Charge lamp burned Check the charge lamp
and the wiring
KiSC issued 06, 2016 A

Kubota GL9000D-AU-B Specifications

General

Brand	Kubota
Model	GL9000D-AU-B
Category	Portable Generator
Language	English