GENERAL
GL6000A-AU-B, GL6000D-AU-B,GL9000A-AU-B, GL9000D-AU-B, WSM
G-4
2. PRECAUTION
• When you disassemble, carefully put the parts in a clean area
to make it easy to find the parts. You must install the screws,
bolts and nuts in their initial position to prevent the reassembly
errors.
• When it is necessary to use special tools, use KUBOTA special
tools. Refer to the drawings when you make special tools that
you do not use frequently.
• Before you disassemble or repair machine, make sure that you
always disconnect the ground cable from the battery first.
• Remove oil and dirt from parts before you measure.
• Use only KUBOTA genuine parts for replacement to keep the
machine performance and to make sure of safety.
• You must replace the gaskets and O-rings when you assemble
again. Apply grease (1) to new O-rings or oil seals before you
assemble.
• When you assemble the external or internal snap rings, make
sure that the sharp edge (3) faces against the direction from
which force (2) is applied.
• Make sure that you try to operate the engine after you repair or
assemble it. Do not try to give a heavy load immediately, if not,
you can cause serious damage to the engine.
9Y1211607GEG0004US0
• Before checking any generator or engine electrical component,
be sure to check that all terminals and connectors are tight.
• After the individual component inspection, also inspect the wire
leads for continuity; that might be the cause of the problem.
• The rotor and stator must be protected when disassembling and
reassembling.
If they are damaged, no power can be generated.
• To maintain the generator's performance and ensure safety,
use only KUBOTA genuine parts for replacement.
• Use extreme caution when working on electrical components.
Electrical shocks cause injury or death.
9Y1211607GEG0018US0
(1) Grease
(2) Force
(3) Sharp Edge
(A) External Snap Ring
(B) Internal Snap Ring
To Next Page
Loading...
Need help?
General
