GENERAL
GL6000A-AU-B, GL6000D-AU-B,GL9000A-AU-B, GL9000D-AU-B, WSM
G-14
7. CHECK AND MAINTENANCE
[1] DAILY CHECK
Check of Engine Oil Level
• Be sure to stop the engine before checking the engine oil
level.
1. Level the engine and check the oil level on the dipstick (1).
2. If the level below the lower line (b), add new engine oil to the
upper line (a).
• When using an oil of different maker or viscosity from the
previous one, drain an old oil.
• Never mix two different type's of oil.
• Use the proper SAE Engine oil according to ambient
temperatures.
Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-10.
9Y1211607GEG0023US0
Check of Coolant Level
• Do not remove the radiator cap while operating or
immediately after stopping. Otherwise, hot water will spout
out from the radiator. Wait for more than ten minutes to
cool the radiator, before opening the cap.
1. Remove the radiator cap and check to see that the coolant level
is just below the port.
2. If low, add coolant to the radiator.
3. Check the recovery tank (1) and keep the coolant level between
the "FULL" and "LOW" marks.
4. If low, add coolant to the recovery tank (1).
9Y1211607GEG0024US0
(1) Dipstick (a) Upper Line
(b) Lower Line
(1) Recovery Tank
To Next Page
Loading...
Need help?
General
