GENERAL
GL6000A-AU-B, GL6000D-AU-B,GL9000A-AU-B, GL9000D-AU-B, WSM
G-27
[13] CHECK POINTS OF EVERY 1 YEAR
Replacement of Air Cleaner Primary Element
1. Remove the air cleaner primary element (2).
2. Install the new air cleaner primary element.
• The air cleaner uses a dry element. Never apply oil to it.
• Be sure to refit the dust cup with arrow ↑ (on the rear)
upright. If the dust cup is improperly fitted, dust passes by
the dust cup and directly adheres to the element.
• Do not run the engine with filter element removed.
• Change the primary element once a year or every 6th
cleaning.
• Do not touch the secondary element (1) except in cases
where replacing is required.
9Y1211607GEG0041US0
Check of Damage in Electric wiring and Loose Connections
1. Check the state of the wiring harness and if it is abnormal,
exchange it.
2. Check the connector's loosening and if the connector is loose,
connect it firmly.
9Y1211607GEG0042US0
[14] CHECK POINTS OF EVERY 2 YEARS
Replacement of Fuel Hoses and Clamp Bands
• Stop the engine when attempting to check the fuel line.
• Never fail to check the fuel line periodically.
The fuel line is subject to wear and aging, fuel may leak out
onto the running engine, causing a fire.
1. Change the fuel hoses (2) together with clamps (1) every
2 years, or whenever they are found to be damaged.
9Y1211607GEG0043US0
Replacement of Radiator Hoses and Clamp Bands
• Before changing the radiator hoses and clamps, be sure to
stop the engine.
• Never open the pressure cap while the engine is running
under heavy loads or immediately after the engine has
stopped. Otherwise, hot water may spray out, scalding the
operator. So make it a habit to wait for about 10 minutes
before opening the cap.
1. To drain the coolant, open the drain plug and remove radiator
cap.
2. Change the radiator hoses (2) and clamps bands (1).
9Y1211607GEG0044US0
(1) Secondary Element (2) Primary Element
(1)Clamp (2)Fuel Hose
(1) Clamp Band (2) Radiator Hose
To Next Page
Loading...
Need help?
General
