PERIODIC SERVICE84
BLubricating Grease Fitting [2WD Model]
Detach the cover, and apply bearing grease.
EVERY 600 HOURS
BReplacing Engine Oil Filter
To avoid personal injury:
A Be sure to stop the engine before changing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of the
new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil
normally decreases a little. Make sure that the engine
oil does not leak through the seal and be sure to check
the oil level on the dipstick. Then, replenish the engine
oil up to the prescribed level.
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
BChanging Transmission Fluid
To avoid personal injury:
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the transmission case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plug.
3. Fill with the new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section.)
4. After running the engine for a few minutes, stop it and
check the oil level again; add oil to prescribed level.
(1) Front wheel hub cover
(1) Engine oil filter
Oil capacity 60 L (63.4 U.S.qts.)
(1) Dipstick
(2) Oil inlet
(A) Oil level is acceptable within
this range.
(1) Drain plug
To Next Page
Loading...
Need help?
General
