EasyManua.ls Logo

Kubota M96SDTM User Manual

Kubota M96SDTM
142 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #113 background imageLoading...
Page #113 background image
91PERIODIC SERVICE
BBleeding Brake System
Consult your local KUBOTA Dealer for this service.
BDraining Clutch Housing Water
The tractor is equipped with a drain plug under the clutch
housing.
After operating in rain, snow or if the tractor has been
washed, water may get into the clutch housing.
Remove the drain plug and drain the water, then install the
plug again.
BReplacing Fuse
The tractor electrical system is protected from potential
damage by fuses.
A blown fuse indicates that there is an overload or short
somewhere in the electrical system.
If any of the fuses should blow, replace with a new one of
the same capacity.
A Before replacing a blown fuse, determine why the fuse
blew and make any necessary repairs. Failure to
follow this procedure may result in serious damage to
the tractor electrical system. Refer to the
"TROUBLESHOOTING" section of this manual or your
local KUBOTA Dealer for specific information dealing
with electrical problems.
(1) Water drain plug

Table of Contents

Questions and Answers:

Kubota M96SDTM Specifications

General IconGeneral
BrandKubota
ModelM96SDTM
CategoryLawn Mower
LanguageEnglish

Summary

SAFE OPERATION

BEFORE OPERATING THE TRACTOR

General precautions and checks before starting tractor operation.

OPERATING THE TRACTOR

Safe practices during tractor operation, including starting and working.

PARKING THE TRACTOR

OPERATING THE PTO

PRE-OPERATION CHECK

DAILY CHECK

OPERATING THE ENGINE

STARTING THE ENGINE

Step-by-step instructions and safety precautions for starting the tractor engine.

OPERATING THE TRACTOR

OPERATING FOLDABLE ROPS

Brake Pedals (Right and Left)

Safety warnings and procedures for using the brake pedals, including interlocking.

Clutch Pedal

PTO

PTO OPERATION

PTO Clutch Control Lever

MAINTENANCE

SERVICE INTERVALS

LUBRICANTS

PERIODIC SERVICE

DAILY CHECK

Thorough daily inspections before operating the machine.

Checking Engine Oil Level

Procedure for checking the engine oil level and adding oil if low.

Checking Coolant Level

How to check the coolant level in the recovery tank and safety for hot coolant.

EVERY 50 HOURS

Checks for the engine start system.

EVERY 600 HOURS

Procedure for changing transmission fluid.

EVERY 2 YEARS

Procedures for flushing the cooling system and changing coolant.

TROUBLESHOOTING

ENGINE TROUBLESHOOTING

Related product manuals