OPERATING THE TRACTOR26
BCreep Lever (if equipped)
Push down the creep lever at " " to obtain low speeds
with range gear shift lever is selected "L" range.
With the creep lever engaged (ON), the range gear shift
lever cannot shift to "H". (The creep mode does not
operate in the high-speed range.)
This shifting requires clutch operation.
C Creep speed should be used only when doing one
of the following jobs:
1. Deep rotary-tilling and harrowing
2. Planting
3. Turf application
C Creep speed can not be used for any of the
followings:
1. Pulling a trailer
2. Front-loader operation
3. Front-blade operation
4. Earth-moving
5. Entering and leaving a field
6. Loading onto and unloading from a truck
To avoid personal injury:
A When you leave the tractor, be sure to apply the
parking brake and stop the engine.
A IN APPLYING THE BRAKES:
A The torque of the wheel axle is extremely
high while creep speed is being used. Be
sure to step down on the clutch pedal
completely before applying the brakes, or
the torque will overcome the brakes.
A When starting to operate the tractor, be sure
to release the parking brakes.
Misuse of the brakes may cause damage to
the transmission and is therefore not
acceptable to KUBOTA for coverage under
the warranty.
A Press the clutch pedal completely down and stop the
tractor's motion before shifting the creep lever.
(1) Creep Lever (A) "LOW".....Creep ON
(B) "HIGH".............Creep OFF
To Next Page
Loading...
Need help?
General
