KYMCO Venox 250 User Manual

13. REAR WHEEL/BRAKE/SUSPENSION
13-9
V
ENOX250/250i
REAR SHOCK ABSORBER
REMOVAL/INSTALLATION
Remove the shock absorber upper mount
nuts and washers and then press down the
motorcycle to pull out the shock absorbers.
Remove the shock absorber lower mount
bolts to remove the rear shock absorbers.
INSTALLATION
The installation sequence is the reverse of
removal.
Torque:Upper 0.8阡1.2kg-m
Lower 3.0阡4.0kg-m
REAR FORK
REMOVAL
Remove the rear wheel.
Remove the rear shock absorbers.
Remove the rear fork pivot nut to remove
the pivot and rear fork.
Remove the drive chain slider and check for
wear or damage.
INSTALLATION
Install the rear fork in the reverse order of
removal.
Tighten the rear fork pivot nut.
Torque: 6.0阡8.0kg-m
After the rear fork is installed, install the
following parts:
Rear shock absorbers
Rear wheel
Drive chain cover
U
pp
er Mount
Lower Mount Nut
Rear Fork Pivot Nu
t
Chain Slide
r
＊
When replacing the rear fork pivot
bushings, apply grease to the pivot
bushing.
Pivot Bushin
g
Rear For
k
Rear Fork Pivot

KYMCO Venox 250 Specifications

General

Brand	KYMCO
Model	Venox 250
Category	Motorcycle
Language	English