17. STARTING SYSTEM
17-3
STARTER MOTOR
REMOVAL
Remove the two starter motor mounting
bolts and the motor.
STARTER MOTOR INSTALLATION
Apply engine oil to the starter motor O-ring
and install the starter motor onto the lower
crankcase by slightly turning it left and
right.
Tighten the two starter motor mounting
bolts.
Install the starter motor cable screw.
After installation, check the starter motor
for proper operation.
Before removing the starter motor, turn
the ignition switch OFF and remove the
battery ground. Then, turn the ignition
switch on to check if the starter motor
operates properly.
＊
Mountin
To Next Page
Loading...
Need help?
General
