19. AFI (AUTOMATIC FUEL INJECTION)
19-31
VENOX250/250i
WTS SENSOR
REMOVAL /INSTALLATION
Drain the coolant from the cooling system
Disconnect the WTS sensor connector from the
sensor.
Remove the WTS sensor and O-ring
Install the new O-ring and WTS sensor.
Tighten the WTS sensor to specified torque.
Torque: 1.2 kgf-m (12 N-m, 8.6 lbf-ft)
Connect the WTS sensor connector.
Fill the cooling system with the recommended
coolant
INSPECTION
Measure the resistance at the WTS sensor
terminals
STANDARD
ºC -20 40 100
KΩ 18.8 1.136 0.1553
＊
Replace the WTS sensor while the engine is
cold.
WTS sensor
＊
Always replace an O-ring with a new one.
To Next Page
Loading...
Need help?
General
