14. HYDRAULIC BRAKE
14-6
VENOX250/250i
BRAKE DISK
Measure the brake disk thickness.
Service Limit: 3.0mm
Measure the brake disk runout.
Service Limit: 0.3mm
BRAKE MASTER CYLINDER
REMOVAL
Drain the brake fluid from the hydraulic
brake system.
Bo
Remove the two master cylinder holder
bolts and remove the master cylinder.
DISASSEMBLY
Remove the piston rubber cover and snap
ring from the brake master cylinder.
Remove the washer, main piston and spring
from the brake master cylinder.
Clean the inside of the master cylinder and
brake reservoir with brake fluid.
＊
Do not splash brake fluid onto any
rubber, plastic and coated parts. When
working with brake fluid, use towel to
cover these parts.
When removing the brake fluid tube bolt,
be sure to place towels under the tube
and plug the tube end to avoid brake
fluid leakage and contamination.
＊
To Next Page
Loading...
Need help?
General
