19. AFI (AUTOMATIC FUEL INJECTION)
19-28
VENOX250/250i
TILT SWITCH
INSPECTION
Support the bike level surface.
Engine stop switch is at “RUN”.
Turn the ignition switch to “OFF”
Remove the screws, washers and tilt switch.
Place the tilt switch vertical as shown, and turn the
ignition switch to “ON”.
Incline the tilt switch 65±10 degrees to the left or
right with the ignition switch turned to “ON”.
If you repeat this test, first turn the ignition switch to
“OFF”, then turn the ignition switch to “ON”.
REMOVAL/INSTALLATION
Disconnect the connector and remove two screws,
then remove tilt switch.
Installation is in the reverse order of removal.
Tighten the mounting screws securely.
＊
Do not disconnect the tilt switch connector
during inspection.
To Next Page
Loading...
Need help?
General
