17. STARTING SYSTEM
17-4
STARTER RELAY
INSPECTION
Turn the ignition switch ON and the starter
relay is normal if you hear a “click” when
the starter button is depressed.
If there is no click sound:
x Inspect the starter relay voltage
x Inspect the starter relay ground circuit
x Check for continuity between the starter
relay yellow/red and green/red wire
terminals
x Check if the side stand position is up.
x Check if is neutral position. If not,
directly apply the clutch lever and push
the starter switch.
Connect a 12V battery across the starter
relay yellow/red and green/red wire
terminals.
Connect an electric tester between the
starter relay large terminals and check for
continuity between the two terminals.
The relay is normal if there is continuity.
Replace the starter relay with a new one if
there is no continuity.
CLUTCH DIODE
INSPECTION
Check the continuity between the wire
terminals.
Normal Direction: Continuity
Reverse Direction: No Continuity
Starter Relay
Clutch Diode
To Next Page
Loading...
Need help?
General
