19. AFI (AUTOMATIC FUEL INJECTION)
VENOX250/250i
THROTTLE BODY/MAP/ISC/TPS
19-33
z
Turn ignition switch off and set up center stand
when do the replacement.
● Check and confirm the voltage above 12V by a
voltmeter after replacement.
● Check and confirm the other connectors are
assembled correctly after replacement.
● Do not damage the throttle body, this may cause
incorrect throttle and idle valve synchronization.
● The throttle body is factory pre-set, do not
disassemble it in a way other than shown in this
manual.
● Do not loosen or tighten the painted bolts and
screws of the throttle body. Loosening or tightening
them can cause throttle and idle valve
synchronization failure.
MAP INSPECTION
Support the bike level surface.
Engine stop switch is at “RUN”.
Turn the ignition switch to “ON”
Measure the ECU voltage between the following
terminals of the MAP connector.
TPS INSPECTION
Support the bike level surface.
Engine stop switch is at “RUN”.
Turn the ignition switch to “ON”
Measure the ECU voltage between the following
terminals of the TPS connector with.
To Next Page
Loading...
Need help?
General
