COMPONENT MAINTENANCE MANUAL
AVIATION RECORDERS
Model FA5000
Mar. 16/16
Table of Contents
23–70–40
Rev. 06 Page xxii
Use or disclosure of information on this sheet is subject to
the restrictions on the cover page of this document.
B. Physical Characteristics 17...............................................
C. Electrical Characteristics 17..............................................
D. Environmental Characteristics 17.........................................
E. Crash and Fire Protection 17.............................................
F. CSMU Torque Requirement 17...........................................
6. INSTALLATION 17............................................................
CVR TESTING AND TROUBLESHOOTING
1. GENERAL 101.................................................................
2. MAINTENANCE PHILOSOPHY 101..............................................
A. Model FA5000CVDR 101.................................................
3. MODEL FA5000CVDR RECORDER IN-SERVICE CHECKOUT 102..................
4. RECORDER INTERFACE UNIT (RIU) 102.........................................
A. READ−OUT CENTER/7 (ROC/7) Interconnects 102..........................
B. READ−OUT CENTER/7 (ROC/7) − Sound Card Setup 106....................
C. READ−OUT CENTER/7 (ROC/7) − CATS Autotest 112.......................
(1) ROC/7 − CATS Autotest using DC power 112.............................
D. READ OUT CENTER/7 (ROC/7) − Autotest Descriptions 120..................
(1) Power Test 120.......................................................
(2) Fault Log 120.........................................................
(3) Bulk Erase 121........................................................
(4) Test Tone 121........................................................
(5) GMT 429 121........................................................
(6) Rotor Speed 121......................................................
(7) Channel Balance 122..................................................
(8) Frequency Response 122..............................................
(9) Signal to Noise and Distortion 123.......................................
The document reference is online, please check the correspondence between the online documentation and the printed version.