Linksys LAPAC1750PRO User Manual

3
Section 1: Getting Started
LAPAC1750PRO Access Point Software User Manual
Figure 1: Administrator UI Online Help
Dynamic and Static IP Addressing on the AP
When you power on the access point, the built-in DHCP client searches for a
DHCP server on the network in order to obtain an IP address and other network
information. If the AP does not find a DHCP server on the network, the AP
continues to use its default Static IP Address (192.168.1.252) until you reassign it
a new static IP address (and specify a static IP addressing policy) or until the AP
successfully receives network information from a DHCP server.
To change the connection type and assign a static IP address by using the Web
UI, see “VLAN and IPv4 Address” on page 29.
NOTE:
If you do not have a DHCP server on your internal network, and do
not plan to use one, the first thing you must do after powering on the
access point is change the connection type from DHCP to static IP. You
can either assign a new static IP address to the AP or continue using the
default address. We recommend assigning a new static IP address so that
if you bring up another WLAN AP on the same network, the IP address for
each AP will be unique.
Recovering an IP Address
If you experience trouble communicating with the access point, you can recover
a static IP address by resetting the AP configuration to the factory defaults (see
“Restoring Configuration” on page 114 and “To Restore the Factory Default
Configuration” on page 114), or you can get a dynamically assigned address by
connecting the AP to a network that has a DHCP server.
Discovering a Dynamically Assigned IP
Address
If you have access to the DHCP server on your network and know the MAC
address of your AP, you can view the new IP address associated with the MAC
address of the AP.
NOTE:
The MAC address of access point is shown on product label and brown
box label.
Installing the Access Point
To access the Administration Web UI, you enter the IP address of the AP into a
Web browser. You can use the default IP address of the AP (192.168.1.252) to log
on to the AP and assign a static IP address, or you can use a DHCP server on you
network to assign network information to the AP. The DHCP client on the AP is
enabled by default.
To install the access point, use the following steps:
1. Connect the AP to an administrative PC by using a LAN connection or a
direct-cable connection.

Linksys LAPAC1750PRO Specifications

General

Modulation	-
VLAN support	Yes
Frequency band	2.4, 5 GHz
Number of users	- user(s)
Channels quantity	- channels
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3ab, IEEE 802.3at, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	1750 Mbit/s
Internal	No
Certification	FCC, CE, IC
Product color	White
Cable lock slot type	Kensington
Ethernet LAN (RJ-45) ports	2
Security algorithms	802.1x RADIUS, WEP, WPA, WPA2
Antenna gain level (max)	5.2 dBi
Input current	2 A
AC input voltage	12 V
Power consumption (typical)	24 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 35 °C
Storage relative humidity (H-H)	10 - 90 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	238 mm
Width	247 mm
Height	43.3 mm
Weight	520 g