8
1. Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side facing up, and ideally at the edge of a table so that the base of the TV
slightly overhangs on it. Please make sure a soft cushioned material (such as a pillow or thick piece of foam) is placed beneath
the screen.
Installing the Base Stand
Attach the TV stand to the TV. Align the screw holes, then secure with a screw driver (not included) using the 4 screws provided.
Installing / Removing the Base Stand
The screw holes will only align if the front of the base stand is at the front of the TV.
• The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be
sure that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with
it. DO NOT exert pressure on the front of the TV at any time because the screen could crack.
• It is recommended that two people take part in the base installation.
Screw x 4
• Please read this instruction manual carefully while setting up your TV.
• If you require additional assistance:
for UK, please call our UK Call Centre on 0344 561 1234.
for Ireland, please call our Ireland Call Center on 1 890 818 575.
To Next Page
Loading...
Need help?
General
