111
8. LIVE EFFECT. Choose between FIXED and BREATHING for the ring whilst the mic is live. For Breathing, use the
SPEED slider to adjust how quickly the effect happens. With 1000ms (1s) is the quickest and 20000ms (20s) is
the slowest.
9. MUTE EFFECT. Choose between FIXED and BREATHING for the ring whilst the mic is muted
10. RESET. Click RESET to revert back to the default colour settings. For Breathing, use the SPEED slider to adjust
how quickly the effect happens. With 1000ms (1s) is the quickest and 20000ms (20s) is the slowest.
11. Per-profile LIGHTSYNC lock. Click to make LIGHTSYNC persistent across all profiles. This locks/unlocks the
lighting settings to be the same for all profiles.
12. GEAR SETTINGS. Click this to take you to the Gear Settings page
13. PROFILE SELECTOR. Use the drop down to change the User Profile you want to configure for. Also it will
indicate if the profile is in a PER-PROFILE CONFIGURATION or in a PERSISTENT CONFIGURATION
14. BACK ARROW. Click the arrow to take you back to the Homepage.
MODE
Switch between the 3 modes by pressing and holding the knob for 2 seconds. The modes will cycle from MICROPHONE
> HEADPHONE > DIRECT MONITORING > MICROPHONE
1. MICROPHONE. Click MICROPHONE to change the colour of the LEDs for the microphone gain. The color palette
will expand, select a new colour using the Hue and Brightness sliders or select a different swatch.
NOTE: By default in this mode, the metering level will be typically shown. Turn the knob to see the microphone gain.
After 2 seconds it will default back to the metering
To Next Page
Loading...
General