SEAWATER COOLED MODELS SERVICE MANUAL NUMBER 23
Page 6A-6 90-861326--1 MARCH 1999
Transom Mounted
72640
a
b
c
d
e
f
g
h
i
j
a-Hose Nipple
b-Nut (4)
c-Gasket - Between Pickup and Transom
d-O-Ring (4)
e-Washer (4)
f-Bolt (4)
g-Plastic Pug
h-Pickup
i-Screen
j-Screw (2)
1. Seal the inside edges of the 1-1/2 in. (38 mm) hole hose nipple.
2. Be certain hose nipple and plastic plug are in place and threads have been sealed with
Loctite Pipe Sealant with Teflon prior to tightening each securely.
NOTE: Use a sharp knife or wood chisel to remove excess plastic plug material so that plug
is flush with pickup casting.
3. Position one flat washer and one rubber O-ring on each 5/16 in. x 4 in. (102 mm) long,
round head bolt as shown. Coat each bolt shaft with silicone sealant or equivalent.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General