VELVET DRIVE IN-LINE TRANSMISSION
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 8A-7
3. Clean strainer tube in suitable solvent.
71307
b
c
a
a-Bushing
b-Spring
c-Plastic Strainer Tube
4. Check oil for the following foreign matter:
• Metal Particles - A few small particles are normal. Larger metal chips are an early sign
of transmission failure which may mean transmission should be disassembled and in-
spected for internal damage.
• Rubber Particles - Indication of cooler hose wear. Hoses should be inspected for
cracks or fraying. Replace damaged hoses.
CAUTION
Avoid severe transmission damage or possible failure of transmission. Strainer
must be properly installed as follows.
5. Install plastic strainer tube with the notch DOWN and OUT toward the side of the case.
71306
a
b
a-Plastic Strainer Tube
b-Notch
6. Install spring.
7. Coat bushing threads with Quicksilver Perfect Seal. Install and torque bushing to 25 lb.
ft. (34 N·m).
8. Coat elbow fitting threads with Quicksilver Perfect Seal and install in bushing. Tighten
securely.
9. Reconnect hose and tighten securely.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General