Mitsubishi 00JCPU User Manual

11 - 6
11.1.4 Procedure for Boot Operation
This section describes a procedure for boot operation.
In the following procedure, indicates an operation on the CPU module side.
Figure 11.3 Flowchart for boot operation
Select "Do boot from standard ROM." in the
Boot file tab of the PLC parameter dialog box.
YES
NO
Start
If the RUN/STOP/RESET
switch is in RUN, set the switch to STOP.
Power off the programmable controller
and then on or reset the CPU module.
Is the special relay
(SM660) on?
End
GX Developer Version 8 Operating Manual
Select [Online] [Write to PLC]
and write the parameters and program
to the program memory.
Select [Online] [Write to PLC (Flash ROM)]
[Write the program memory to ROM)]
and write the program memory data
to the standard ROM.
Section 5.1.5
(continued from Section 11.1.3)

Mitsubishi 00JCPU Specifications

General

Brand	Mitsubishi
Model	00JCPU
Category	Controller
Language	English