Mitsubishi 00JCPU User Manual

11 - 13
CHAPTER11 PROCEDURES FOR WRITING PROGRAM TO CPU MODULE
1
2
11
4
5
6
7
8
11.2 High Performance Model QCPU, Process CPU, and Redundant CPU 11.2.4 Procedure for Writing Multiple Programs
1)
YES
NO
YES
NO
2)
Write to PLC screen
*4
*3
*2
*1
Set local devices?
Set the local device range in the Device
tab of the PLC parameter dialog box.
Set a file name for the local devices in the
PLC file tab of the PLC parameter dialog box.
Use the common pointers?
Set the start pointer number in the PLC
system tab of the PLC parameter dialog box.
Set the names and execution conditions
of programs to be executed in the
Program tab of the PLC parameter dialog box.
Set the parameter-valid drive
with the DIP switches (SW2, SW3).
Connect the personal computer to which GX
Developer is installed to the CPU module.
Set the RUN/STOP switch to STOP,
turn the RESET/L.CLR switch to reset clear
position, and power on the CPU module
(the ERR. LED turns on).
Select [Online] [Format PLC memory]
in GX Developer and format
the program memory.
Select [Online] [Write to PLC]
"Program memory/Device memory" for
"Target memory" in GX Developer and
write the parameters and created programs.
Section 9.13.2
Section 9.13.2
Section 9.9
Section 2.3

Mitsubishi 00JCPU Specifications

General

Brand	Mitsubishi
Model	00JCPU
Category	Controller
Language	English