Mitsubishi 00JCPU User Manual

11 - 14
*1: The parameter-valid drive is set to the program memory (drive 0) with the DIP switches by default (SW2: Off, SW3: On).
To store parameters in the standard ROM or memory card, change the settings of the DIP switches.
*2: For procedures when the Redundant CPU is used, refer to the following.
QnPRHCPU User's Manual (Redundant System)
*3: When storing the file register and initial device value to the standard RAM or memory card (except the Flash card), format
the memory used.
*4: Write each data in the memory as shown below:
• Program: Program memory
• Parameter: Memory set in the parameter-valid drive
• Initial device value: Memory set in the PLC file tab of the PLC parameter dialog box
Figure 11.6 Flowchart for writing multiple programs
NO
NO
2)
YES
YES
Power off the programmable controller
and then on or reset the CPU module.
Set the RUN/STOP switch to RUN to change
the CPU module in the RUN status.
Is the ERR. LED
on the CPU module on
(flashing)?
Check the error cause in the System Monitor
screen displayed by selecting [Diagnostics]
[System Monitor] in GX Developer or in the
"PLC diagnostics" screen and remove the error.
Start boot operation?
End
QCPU User's Manual
(Hardware Design, Maintenance and Inspection)
To Section 11.2.5

Mitsubishi 00JCPU Specifications

General

Brand	Mitsubishi
Model	00JCPU
Category	Controller
Language	English