11 - 1
11
CHAPTER 11 MANUAL CONTROL
The details and usage of manual control are explained in this chapter.
In manual control, pulse output commands are issued during a JOG operation and an
inching operation executed by the turning ON of the JOG START signal, or from a
manual pulse generator connected to the QD75.
Manual control using a sequence program from the CPU module is explained in this
chapter. Refer to GX Configurator-QP Operating Manual for an explanation of manual
control (JOG operation, inching operation and manual pulse generator operation) using
the peripheral devices.
11.1 Outline of manual control ........................................................................................11- 2
11.1.1 Three manual control methods..................................................................11- 2
11.2 JOG operation..........................................................................................................11- 4
11.2.1 Outline of JOG operation ...........................................................................11- 4
11.2.2 JOG operation execution procedure .........................................................11- 7
11.2.3 Setting the required parameters for JOG operation ................................. 11- 8
11.2.4 Creating start programs for JOG operation..............................................11- 10
11.2.5 JOG operation example ............................................................................11- 13
11.3 Inching operation ....................................................................................................11- 16
11.3.1 Outline of inching operation ......................................................................11- 16
11.3.2 Inching operation execution procedure ....................................................11- 19
11.3.3 Setting the required parameters for inching operation ............................11- 20
11.3.4 Creating a program to enable/disable the inching operation...................11- 21
11.3.5 Inching operation example........................................................................11- 24
11.4 Manual pulse generator operation .........................................................................11- 26
11.4.1 Outline of manual pulse generator operation...........................................11- 26
11.4.2 Manual pulse generator operation execution procedure .........................11- 30
11.4.3 Setting the required parameters for manual pulse generator operation .11- 31
11.4.4 Creating a program to enable/disable the manual pulse generator
operation ...................................................................................................11- 32
To Next Page
Loading...
Need help?
General
