Motorola TETRA MTM5400 User Manual

4.9
Individual Setup
This menu item allows you to set call settings for individual calls.
4.9.1
Gateway Mode
This sub-menu item allows you to set a forwarding address for incoming calls in Gateway mode.
4.9.1.1
Setting Forwarding Address
Procedure:
1 From the home screen, press the Menu key.
2 Select Individual Setup→Gateway Mode→Forwarding Address.
3 Enter the number where the call is to be forward to and press OK.
4.9.2
Trunked Mode
This sub-menu allows you to set call waiting and call forwarding for your radio.
4.9.2.1
Enabling or Disabling Call Waiting
When and where to use: To enable or disable Call Waiting for your radio.
Procedure:
1 From the home screen, press the Menu key.
2 Select Individual Setup→
Trunked Mode→Call Waiting.
3 Select On to enable Call Waiting, or Off to disable it.
4.9.2.2
Setting Call Forwarding
When and where to use: To enable or disable Call Forwarding for your radio. If radio is not in TMO
mode, selecting call forwarding will results in an Invalid Keypress tone and Service Restricted
message.
Procedure:
1 From the home screen, press the Menu key.
2 Select Individual Setup→Trunked Mode→Call Forwarding.
3 Select one of the following options:
• Config Sending – Enable or disable call forwarding. Select On to enable call forwarding.
• Config – Set predefined condition messages for calling radio. You can select more than one
messages:
• Always
• Busy
68015000180-MR
Chapter 4 : Main Menu
110

Motorola TETRA MTM5400 Specifications

General

Operating Temperature	-30°C to +60°C
IP Rating	IP54
Channels	Up to 1000
RF Power Output	10W
Frequency Bands	380-430 MHz, 806-870 MHz