Parameter Description
SENSITIVITY (Detect
mode only)
When MODE is set to DETECT (see above), SENSITIVITY lets you
adjust the sensitivity of the transient detection. Higher values will
cause more Slices to be detected because more transients will be
recognized, lower values will result in less Slices. This parameter
should be adjusted until all the musically significant slices are being
detected in the waveform.
BPM (BPM Mode) Selects how the tempo is defined: If you select AUTO, MASCHINE
will calculate the tempo automatically. If you select MANUAL, you
can enter the tempo in BPM manually.
ADJUST If BPM is set to AUTO, you can choose between the tempo that
MASCHINE detected, or half or double of that tempo. If BPM is set
to MANUAL, you can adjust the tempo manually.
When MODE is set to DETECT, a second section of parameters is available at the bottom of the
left display: the ENGINE section.
â–º
When MODE is set to DETECT, press the Right Page button to show the ENGINE section.
The ENGINE section.
This ENGINE section contains a single parameter: ZERO-X.
Parameter
Description
ENGINE Section (Detect mode only)
ZERO-X (Zero
Crossing, Detect mode
only)
When MODE is set to DETECT, activate ZERO-X to force the detected
Slices to be created on the closest locations where the audio signal
crosses the zero value. This can be helpful to avoid clicks when
playing back Slices in another sequence.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE - Manual - 787
To Next Page
Loading...
Need help?
General
