S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Managed Pro Switches
Configure Switching User Manual167
Configure IGMP Snooping for VLANs
To configure IGMP snooping settings for VLANs:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Discover or Change the Switch IP
Address on page 12.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is
password.
The System Information page displays.
5. Select Switching> Multicast > IGMP Snooping > IGMP Snooping VLAN Configuration.
6. Select the check boxes for one or more VLANs.
If you select the check box for a single VLAN, the VLAN ID displays in the VLAN ID field.
Type The type of the entry. Static entries are those that are configured by the end
user. Dynamic entries are added to the table as a result of a learning process or
protocol.
Description The text description of this multicast table entry. The options are Management
Configured, Network Configured, and Network
Assisted.
Interface The interfaces that are designated for forwarding (Fwd) and filtering (Flt) for the
associated address.
Table 44. IGMP Snooping Table information (continued)
Field Description