Network Settings
25
ProSAFE 8-Port and 16-Port Gigabit Click Switch
7. Make sure that the IGMP Snooping Status Enable radio button is selected.
8. In the VLAN ID Enabled for IGMP Snooping field, type the name of the VLAN.
9. Click the Apply button.
Your settings are saved.
Set Up Link Aggregation Groups
Link aggregation groups (LAGs) allow you to combine multiple Ethernet links to a single
logical link. Network devices treat the aggregation as if it were a single link, which
increases fault tolerance and load sharing. Configure LAG membership before you
enable the LAG.
Note: LAGs are supported in switch model GSS116E, but they are not
supported in switch model GSS108E.
Use the ProSAFE Utility to Enable LAGs
You must set up LAG membership before you enable LAG.s
To enable LAGs:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection.
2. Double-click the ProSAFE Plus Utility icon.
The configuration home screen displays a list of Plus switches that it discovers on the
local network.
3. Select a switch.
If you do not see the switch, click the REFRESH button.
4. Click the APPLY button.
You are asked to enter the password for the switch.
5. Enter the switch’s password in the password field.
The switch’s default password is password.
The Switch Status screen displays.
To Next Page
Loading...
Need help?
General