Supplemental Information
73
ProSAFE 8-Port and 16-Port Gigabit Click Switch
Factory Default Settings
You can return the switch to its factory settings. Use the end of a paper clip or some other
similar object to press and hold the /Factory Defaults button on the back panel of the switch
for at least four seconds. The switch resets, and returns to the factory settings that are shown
in the following table.
Table 2. Factory default settings
Factory Default Setting GSS108E GSS116E
Switch name N/A (empty) N/A (empty)
Switch password password password
IP address 192.168.0.239 192.168.0.239
Subnet mask 255.255.255.0 255.255.255.0
Gateway address 192.168.0.254 192.168.0.254
DHCP mode Enabled Enabled
Port mirroring Disabled Disabled
Loop detection Disabled Disabled
IGMP snooping Enabled Enabled
Port LED control Link speed and activity Link speed and activity
LAG N/A Disabled
VLAN Disabled Disabled
QoS 802.1p/DSCP based 802.1p/DSCP based
Rate limit Disabled Disabled
Broadcast filtering Disabled Disabled
Port mode Auto negotiation Auto negotiation
Flow control Disabled Disabled
To Next Page
Loading...
Need help?
General