EasyManuals Logo
Home>Nilfisk-Advance>Floor Machine>SC401 Series

Nilfisk-Advance SC401 Series User Manual

Nilfisk-Advance SC401 Series
173 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
114Service Manual – SC401, SCRUBTEC 344 24 - Electrical System (Battery)
Battery Charging
Note: Charge the battery when only one LED of the battery symbol is ashing, or at the end of each
shift. Keeping the batteries charged make their life last longer.
CAUTION: When the batteries are discharged, charge them as soon as possible, as that condition
makes their life shorter. Check for battery charge at least once a week.
CAUTION: If the machine is not equipped with on-board battery charger, choose an external
battery charger suitable for the type of batteries installed.
WARNING: When using lead (WET) batteries, battery charging produces highly explosive
hydrogen gas. Charge the batteries in well-ventilated areas and away from naked
ames. Do not smoke while charging the batteries. Keep the recovery tank lifted until
the battery charging cycle is over.
WARNING: Pay careful attention when charging lead batteries (WET) as there may be battery uid
leakages. The battery uid is corrosive. If it comes in contact with skin or eyes, rinse
thoroughly with water and consult a physician.
1. Raise the recovery tank.
2. (For WET batteries only) Check the level of electrolyte inside the batteries. If necessary, unscrew the
caps and top up.
3. When the correct level is restored, close the caps and clean the tops of the batteries.
Charging the Batteries with an External Battery Charger
1. Check that the external battery charger is suitable by referring to the relevant Manual. The external
battery charger voltage rating must be 24 V.
2. Disconnect the red battery connector (A) which is tted with a handle, and connect it to the external
battery charger.
3. Connect the external battery charger to the electrical mains.
4. After charging, disconnect the external battery charger from the electrical mains and from the battery
connector.
5. Connect the red battery connector (A) to the connector (B) xed to the machine.
WARNING: Never connect the external battery charger to the opposing part of the connector (B)
xed to the machine. The electronic system could be irreparably damaged.
Figure 8:
B
A

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-Advance SC401 Series and is the answer not in the manual?

Nilfisk-Advance SC401 Series Specifications

General IconGeneral
BrandNilfisk-Advance
ModelSC401 Series
CategoryFloor Machine
LanguageEnglish

Related product manuals