126Service Manual – SC401, SCRUBTEC 344 30 - Solution System
Adjusting of Detergent Concentration in the Washing Water
The system for mixing the detergent in the washing water is automatically activated when the brush is
running.
The percentage of detergent added to the washing water is set to 0,25%, to change the setting perform
press the Solution button
for more than two seconds to perform the adjustment. The set percentage
depends on the relevant LED turned on, on the battery symbol.
Figure 1:
To change the setting or to reset it (all LEDs off), press Solution button to set the percentage.
Note: The setting is stored 3 minutes after releasing all push-buttons. Detergent percentage setting
is stored into memory, even if the machine is switched off.
To Next Page
Loading...
Need help?
General
