145Service Manual – SC401, SCRUBTEC 344 34 - Scrub System, Disc
Brush Deck (continues)
8. Pay attention to disconnect the detergent hose (H) (see “detergent pump” paragraph).
9. Remove the tie cable to release the motor harness.
10. Unscrew the 2 retaining nuts (I), (J) and disconnect the brush motor power supply cables.
11. Extract the brush deck (K) from beneath the solution tank.
Figure 8:
H
I
J
K
Installation
12. Assemble the components in the opposite order they were removed in, ensuring the brush motor power
supply cable polarities are correct.
To Next Page
Loading...
Need help?
General
